DIY Stud Earring Holder

Materials: - old iPhone box - scrapbook paper - matching felt sheet - 5 short pencils (that fit in the box) - glue - scissors - a ruler

 First, you are going to want to cut off the barcode form the bottom of the scrapbook paper. Then, decide whether you are going to use the top or bottom of the box and wrap it. Glue it down. 

Fold the sides in and glue them down.

    Cut along the lines shown.
    (left) Cut along the bottom crease. (right) Cut any extra off the top.

Fold the tabs in and glue them down.

Fold the bottom part up and glue down.  Trim it a little if needed.  Either fold the tab in and glue (left)  or cut the corners and glue it down (right). (I think it is easier to glue it down when you cut the corners.)

Now, fill the box with cotton balls and cover it with a piece of cardboard or extra piece of

scrapbook paper.

Make sure your pencils fit in the box.
Measure the length of the box and cut that much felt. ​

Cut a piece of felt big enough for a pencil. Cut 4 more for the other pencils.

Cover your surface. It gets messy!

Place the pencil off to one side of the 
felt so that you have room to roll the pencil. 

---

  Fold the felt over the pencil and roll.
  Hold it down for 2-3 minutes or until secure.
  I had to leave all 5 under a book over night to completely dry and be secure.

Now that all of them are dry and secure place  them in the box on top of the cardboard (or scrapbook paper). Put your earrings in and enjoy!